Comparison ledger
Laurell EDC-HL-23, Laurell Lz-23, side by side. Every value shown is drawn from the cited encyclopedia entries.
| Attribute | EDC-HL-23Laurell | Lz-23Laurell |
|---|---|---|
| OEM | Laurell | Laurell |
| Category | Spin coater | Spin coater |
| Wafer size | 150mm | 150mm |
| Process node | — | — |
| Introduced | — | — |
| Production run | — | — |
| Lifecycle | — | — |
| Lifecycle milestones | — | — |
| Control system | — | — |
| Generation | 650-series | — |
| Family | Laurell EDC-HL-23 | Laurell Lz-23 |
| Cited variants |
|
|
| Specifications | ||
| Process controller | 650-series process controller[1] | 650-series process controller[2] |
| Wafer capacity | Up to 150 mm wafers[1] | — |
| Substrate capacity | Up to 5 in x 5 in (127 mm x 127 mm) substrates[1] | — |
| Maximum rotation capability | 12,000 RPM with vacuum hold-down[1] | — |
| Recommended operating speed | 3,000 RPM with non-vacuum chucks[1] | — |
| Power | 95 to 240 VAC, 47/63 Hz, ~300 Watts[1] | 95 to 240 VAC, 47/63 Hz, approximately 300 W[2] |
| Nitrogen/CDA seal purge pressure | 60–70 PSIG (4–5 bar)[1] | — |
| Vacuum recommendation | 25–28 inches Hg with 4.5 SCFM at 0 inches Hg[1] | — |
| Series | — | 650-series[2] |
| Maximum wafer size | — | Up to 150 mm wafers[2] |
| Substrate size | — | 5 in × 5 in (127 mm × 127 mm)[2] |
| Maximum rotational speed | — | 12,000 RPM (based on a 100 mm silicon wafer)[2] |
| Nitrogen/CDA process/seal purge | — | 60–70 PSIG (4–5 bar)[2] |
| Vacuum suggestion | — | 25–28 inches Hg with a flow volume of 4.5 SCFM at 0 inches Hg[2] |
Plan your fab
Building a Spin coater process? Get a complete equipment list.
Open the fab equipment planner →